
Page | 150
Figure 136: SV Handbrake cable
arrangement
S3 Handbrake cable arrangement
Locate the fixed nylon boss on the outer
cable into the LH bracket on the chassis
above the differential and locate the
adjuster on the outer cable into the RH
bracket on the differential.
Secure the handbrake assembly to the
chassis using the screws (fastener
pack 30P012A Item 4) and nyloc nuts (9).
There are two holes front hole in the
handbrake mechanism to allow
adjustment of the handbrake lever in the
'off' position.
Connect the electrical spade connector to
the top switch on the handbrake.
The two ends of the handbrake cable
emerge from the rear of the transmission
tunnel rearwards. Each end of the
handbrake cable should be routed over
the respective driveshaft then turned
through 180 under the driveshaft and
secured to the chassis diagonals, using
cable ties, just outboard of the 'A' frame.
Finally the handbrake cable is turned back
on itself and attached to the calliper
through the abutments, refer to Figure
138.
NOTE
Ensure that cable cannot foul flexible
brake pipe during suspension movement.
Figure 137: Handbrake cable routing
S3 (non-adjustable side)
The handbrake cable should not be
adjusted until the transmission tunnel
Kommentare zu diesen Handbüchern